Apex Flat-Faced Action Enhancement Trigger & Duty/Carry Kit for M&P Shield
This kit is a combination of the Apex Duty/Carry Kit for the M&P Shield and the Apex Flat-Faced Action Enhancement Trigger for the M&P Shield (9/40 only). The Trigger Kit directly replaces the factory hinged trigger with a solid aluminum trigger body which reduces pre-travel and over-travel by approximately 20%. It features a smooth, flat face with a center mounted pivoting safety that maintains factory safety values.
The Apex Duty/Carry Kit for the M&P Shield was designed to provide the Shield pistol owner a smooth, consistent trigger pull that is approximately 2 lbs lighter (based on variations in factory tolerances) with the advantages of shorter over-travel and more detectable trigger reset. However, armorer or gunsmith installation of the Ultimate Striker Block (USB) into the Shield slide is strongly recommended**.
– Reduces trigger pull by approximately 2 lbs.
– Smooth uptake and reset
– Reduces pre-travel
– Reduces over-travel
– Reduced reset
– Center mounted pivoting safety maintains factory safety values
Applicable To What Gun(s)
Works with all Smith & Wesson M&P Shield Pistols in 9mm and .40 calibers. NOT for use in the Shield 45.
In The Package
1 ea. Aluminum Shield Flat-Faced Action Enhancement Trigger (9/40 only)
1 ea. Trigger Return Spring Installation Shield Slave Pin (to assist with trigger return spring installation)
1 ea. Fully machined .45 Sear
1 ea. Ultimate Striker Block Kit
1 ea. Ultimate Striker Block
1 ea. Striker Block Spring
1 ea. Talon Tactical tool
1 ea. Shield Carry Spring Set
1 ea. Sear Spring (1/8")
1 ea. Rated Trigger Return Spring
|Manufacturer||Apex Tactical Specialties|
|Item Category (only for Taxify)||No|