Dark mode is

ARC Division Arc Sparc 9mm Compensator For Glock Gen 5


In stock

ARC Division Arc Sparc 9mm Compensator For Glock Gen 5

As low as $92.00
Rainier Arms Free Ground Shipping

The Arc Sparc G5 is the newest of their comps designed to be compatible with Gen 5 G19, G17, and G45. The Sparc will help you shoot flatter and faster in all situations. Arc Division offer their comp threaded in the standard 1/2×28.


The SPARC compensator, in the hands of a novice shooter, reduces recoil by 50%.

  • Material: 7075 Aluminum
  • Coating: BLACK Type 3 Hardcoat Anodizing, GOLD Type 2 Anodizing (both 70-73 Rockwell)


Why use a comp? Easy. Using a compensator on your handgun mitigates the gasses in a manner that helps you run your gun flatter and faster. Dispersing the blast upward and outward is what helps keep your firearm level while shooting.


Their set screw design wedges the compensator onto your barrel, pinching it and keeping it tight during extended use. ONLY SECURE SET SCREWS ONTO THE BARRELS SHOULDERS AND NOT THE THREADING. Depending on your exact barrel, the comp may sit flush to the slide or have a small gap. DO NOT tighten set screws onto the threading, this may cause damage to the threading.



  • Compensator
  • Red Loctite
  • Allen Key
  • Set Screws
  • Written Instructions


Arc Division compensators are manufactured and anodized in the USA to the highest quality and standard. They use 7075 aluminum for the Sparc Compensator and their BLACK is Type 3 Hard Coat Anodized while their GOLD is Type 2 Anodized to achieve the color. Both meter 70-73 on the rockwell hardness chart. Arc Division have had no issue with either coating thus far, but estimated the black will out last the gold after continuous abuse and use. They recommend you to clean your comp when you clean your gun to maintain its luster and finish from corrosion.


Please note: Adding their compensator to your pistol, in rare circumstances, can effect your reliability and may require some fine tuning. Arc Division have ran thousands of rounds through multiple firearms in different set ups with little to no issues, but this does not mean that an issues in reliability can not occur. Depending on your existing recoil spring and striker spring, it may effect your slides ability to cycle. Thus far they have not had any recorded issues on tested firearms. Arc Division recommends a Qualified Gunsmith to install or make any modification to your firearm. The Aluminum 7075 compensator will eventually wear out after years of use over thousands of rounds. It depends on the load and weight of the rounds used consistently, but they have built them to last with the best material out there.

DISCLAIMER: This product is not manufactured, authorized, endorsed, or warranted by GLOCK. GLOCK does not warrant or represent that this product is compatible with GLOCK pistols.

More Information
Product Type Compensator
Manufacturer ARC Division
Option Glock
Google Customer Reviews Google Customer Reviews