Dark mode is

Arc Division Sig Sauer P320 Arc FLUX Compensator - 1/2x28


In stock

Arc Division Sig Sauer p320 Arc FLUX Compensator - 1/2x28

As low as $85.00
Rainier Arms Free Ground Shipping

The Arc Flux v2 is the newest of the Arc Division line of compensators for the Sig P320. The FLUX will help you shoot flatter and faster in all situations. We offer the Flux comp threaded in 1/2x28.

The v2 is designed to maximize gas mitigation to enhance your firearms reliability and ability to reduce recoil.

  • Weight: 0.8 OZ w/ setscrews installed.
  • Size 1.2 lenght x 1 width x .8 tall
  • Material: 7075 Aluminum
  • Coating: BLACK Type 3 Hardcoat Anodizing, GOLD Type 2 Anodizing (both 70-73 Rockwell)

Why use a comp? Easy. Using a compensator on your handgun mitigates the gasses in a manner that helps you run your gun flatter and faster. Dispersing the blast upward and outward is what helps keep your firearm level while shooting.

Arc Division set screw design wedges the compensator onto your barrel, pinching it and keeping it tight during extended use. ONLY SECURE SET SCREWS ONTO THE BARRELS SHOULDERS AND NOT THE THREADING. Depending on your exact barrel, the comp may sit flush to the slide or have a small gap. DO NOT tighten set screws onto the threading, this may cause damage to the threading.


  • Compensator
  • Red Loctite
  • Allen Key
  • Set Screws
  • Written Instructions

Arc Division compensators are manufactured and anodized in the USA to the highest quality and standard. Both meter 70-73 on the rockwell hardness chart. They have had no issue with either coating thus far, but we estimate the black will out last the gold after continuous abuse and use. Arc Division recommend you clean your comp when you clean your gun to maintain its luster and finish from corrosion.

Please note:
Adding their compensator to your pistol, in rare circumstances, can effect your reliability and may require some fine tuning. Arc Division have ran thousands of rounds through multiple firearms in different set ups with little to no issues, but this does not mean that an issues in reliabilty can not occur. Depending on your existing recoil spring and striker spring, it may effect your slides ability to cycle. Thus far they have not had any recorded issues on tested firearms. Recommend a Qualified Gunsmith install or make any modifactions to your firearm. The Aluminum 7075 compensator will eventually wear out after years of use over thousands of rounds. It depends on the load and weight of the rounds used consistently, but we have built them to last with the best material out there.

More Information
Product Type Compensator
Manufacturer ARC Division
Option Sig Sauer
Google Customer Reviews Google Customer Reviews