OPF-G, DPP (Optics Platform, Forward Controls, Delta Point Pro) is the latest member of the OPF line.  OPF-G, DPP uses the same proven design of the OPF-G, RMR to keep the Delta Point Pro immobile, the simplest and most effective way to prevent sight to plate mounting screws from loosening and shearing.

While Leupold's Delta Point Pro uses 4 recoil lugs (twice as that of the RMR's) and beefier mounting screws, the challenges of keeping the sight on the plate without loosening or shearing the sight to plate screws are not very different from those of the RMR.  OPF-G, DPP has a front and rear fence, the tight tolerances of the plate to slide, and sight to plate insures minimum movement along the bore in recoil.

OPF-G, DPP ships with 2 plate to slide screws (M3 0.5mm x 6mm), 2 Delta Point Pro screws (M4 .7x15.8mm), a T10 and a T15 wrench.  The screws included with the Delta Point Pro are the same screws that ship with the Dela Point Pro, the 2 screws they provide are simply spares.  A torque wrench is necessary to properly install both the plate to slide, and sight to plate screws.

Torque value:

• Plate to slide: 13in/lb
• Sight to plate: 25in/lb

Billet machined in 4140, hat treated and black nitride coated.

OPF-G, DPP is a collaboration between Tangodown and FCD.  Proudly designed and made in the USA.

Please NOTE:

• Do not use OPF-G, DPP with Holoson SCS320, it will damage the plate.
• OPF-G, DPP is compatible with Glocks that use Glock's Set 01 plates (17, 19, 22, 23, 26, 34, and 45).  G40 (10mm) uses Set 02 plates that are slightly wider, while OPF-G, DPP still works with it, it will not completely fill the MOS cut's width.
• OPF-G, DPP is compatible with the new EOTech EFLX, but the DPP sight to plates are longer, if you are buying OPF-G, DPP for use with EFLX, be sure to use the screws that came with your EFLX sight.
• Due to the DPP's rather tall height, it requires equally tall backup sights for lower 1/3 co-witnessing.  Ameriglo's GL-808 provides lower 1/3 co-witness.