The Zev Technologies Gen 4 Magazine Release for the Glock was designed with an aggressive rearward angle and a non-slip textured face that matches the factory finish of your Gen 4 grip. This Mag release is a drop-in replacement part. Not compatible with Gen3 models.
- The Zev Technologies™ Generation 4 Magazine release for the Glock® is constructed from Billet 6061 Aluminum and Mil Spec hard anodized Black.
- It has a checkered non-slip face;for a more tactile engagement surface.
- The contact point on the mag release face is ergonomically angled to the rear to allow ease of manipulation in performing magazine changes
- The Mag Release takes minutes to install with the use of needle nose pliers and a long shaft, slim, flat head screwdriver.
Note:It is easiest to remove and replace the factory Glock® Mag-release Catch Spring for the magazine release installation. Then installing it back in its pin position after you remove the factory unit and replace it with the ZEV¦ component.
ZEV Parts always incorporate design, feel and performance.