JMAC Customs RRD-360 28F KeyMount (KeyMicro) - 1/2-28

The RRD-360 Muzzle Device from JMAC Customs is unlike others on the market today. This device vents gasses 360 degrees away from your muzzle requiring less effort from the shooter to manage recoil. The use of additional, smaller ports, allows the gasses to disperse in a less concentrated pattern which reduces flash and concussion when compared to a standard muzzle brake. Due to the 360 design, this device does not require timing which makes installation much more simple and does not require shims or crush washer.

With the advancement of suppressor technology and the popularity of the KeyMount mounting system, the 360-28F was designed to allow users to install a KeyMount compatible muzzle device on their firearm that not only worked well, but also complemented the look of the firearm. The 360-28F is designed to sleeve over the factory barrel approximately .98" and partially cover the tri-lugs (if equipped). This allows the user to install their suppressor closer to the receiver for a shorter overall length and a better balanced firearm. In addition to a KeyMount compatible suppressor, the 360-28F is also compatible with any of their Blast Diversion Shields (BDS) in combination with the proper KeyMount adapter.

The 360-28F will work on any barrel with 1/2-28 threads that extends a minimum of 1" beyond the handguard/gas block/front sight with a diameter less-than 0.7". 

Features:

• 3 layers of protection for your suppressor
• No timing / shims not required
• Lightweight
• Minimal added length
• Compatible with dozens of suppressors
• Reduced Recoil

Specifications:

• 1/2-28 Barrel Threads
• 2.050" long (adds approx 0.85")
• Sleeves barrel 0.98"
• 10mm Bore
• KeyMount and KeyMicro Compatible
• 17-4ph Stainless
• Black Nitride
• Facemount device

Compatibility:

• HK MP5 and variants with 1/2-28 threads.
• AR-15 - Must have "government profile barrel" or barrel with diameter behind the threads of <0.7".
• SCAR-16 - Must have 1"+ from has adjustment to end of barrel.
• ACR - Must have 1"+ from gas adjustment to end of barrel.
• FS2000 - Must be threaded 1/2-28 and must have 1"+ from has adjustment to end of barrel.
• AUG - Must be threaded 1/2-28.
• Scorpion EVO3 - Must not have 18mm threads behind 1/2-28. Compatible with Micro EVO3 S2 "Micro".
• Galil ACE - Pistol/rifle compatible. Measure to ensure fitment.
• IWI Tavor

Please Note:

• *Not intended or recommend for barrels shorter than 10.5” when using rifle calibers(see below)
• *When testing these devices, we found that high rates of fire such as full auto or 
• “mag dumps” could cause damage to the device due to the excess heat, pressure, and gasses from unburnt powder on shorter barrels.
• This device is designed to be tightened against the face of the barrel. You must use JMAC's face shims or your barrel MUST be faced to properly time this muzzle device.