Springer Precision STI/SVI 2011 140/170mm Base Pad
Basepad
In Stock
In Stock
In Stock
In stock
Disclaimer: As with all competition geared changes, always make sure you test and check your gear before you take it to a competition setting. With 140mm/170mm magazine configurations especially, check the magazine in a USPSA 140mm/170mm gauge to make sure it fits. With mass produced items like magazines, sometimes they can vary slightly from one to the next, often in the magazine lips that connect with the magazine extension/basepad.
Springer Precision 140mm / 170mm basepads for STI/SVI 2011 are CNC machined from aluminum and hard anodized for a long service life. These basepads for 2011 magazines include special flaring that makes installation and removal much easier than many conventional basepads. Springer Precision also made a subtle relief cut “well” within the basepad that gives you a little more room for spring compression.
The unique locking mechanism allows a very solid attachment with a simple backing out of the discrete set screw. They fit the USPSA magazine gauge for 140mm and 170mm mags. The unique attachment design provides a low profile, sleek design that is very stable and easy to remove.
Grams Extra Capacity Follower Kit
Please read the four options below carefully.
FKS-11 - For use in STI (1st & 2nd gen)/SV/SPS/CR mags (all calibers - except 1st gen STI mag, 9mm x 19mm spacer plate configuration), that measure up to 145mm long with a base pad attached.
FKS-13 - Same as above but for up to 171mm magazine length.
FKS9-11 - For use in STI (1st gen, 9mm x 19mm) magazines WITH spacer plate installed, that measure up to 145mm long with base pad attached.
FKS9-13 - Same as above but for up to 171mm magazine length.
